1 / 8
Forged Carbon Fiber Tirelevermould — image 1
1 / 8

Forged Carbon Fiber Tirelevermould

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A Mould for using up your leftover carbon fiber to make the strongest Tirelevers.

Rating
0 / 5
Likes
13
Downloads
18
Makes
0
Views
325
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial

I always have leftovers when doing layups on bigger Carbon fiber projects, and I hate to throw them away. I also had the issue of breaking off some tirelevers when trying to mount or remove my tubeless bicycle tires. So I decided to finally make a mould for a carbon fiber tirelever.

The Mould is a compression mould. You just weigh out the Material (30g Total), push it into the mould, and clamp it shut. 

I included 3 Versions.

  • a Version for 8mm Dowel pins (that's what I am using)

  • a Version for 3/8 inch Dowel pins (sounded like a common size for everyone not using metric)

  • a Version that has pins included (not recommended, they will probably break off after 1-2 uses because of the resin squeezeout) 

I just use some liquid release agent and brush on 2 coats. That's quick and works great. If you don't have much experience, use your normal releaseagent and put on a few coats.

This is intended to use up your leftovers. I usually just use leftovers where the carbon tows are cut to about 5-10mm length. If you want the ultimate strength, take a bit more care and use longer tow that is properly oriented along the part and where the tow sits nicely all the way to the tip of the tirelever. 

I recommend 1 part fiber to 2 parts resin for the simplest and best results. In Total about 30g (10-12g fiber and 18-20g Resin)

When the mould is closed, the end of the plunger should sit flush with the rest of the mould. It should require quite a bit of force to get it closed. Close it slowly and wait every 1mm so the resin has time to flow. If you don't have enough material in the mould, you will have voids. If you have too much, the mould won't close compleatly and the tirelever will be too thick to use.

I also made a preplunger that can be used to roughly squeeze the carbon fiber mixture into place before using the plunger to press everything together. The preplunger is not necessary. I always just use a mixing stick to roughly push everything into position.

For demoulding, remove the pins first and then use a wedge to open the mould. If you saved on release agent you might have to use a pair of pliers to get the tirelever off the plunger.

After demoulding, you can sand the surface smooth, and I would highly recommend using some epoxy that is certified for skin contact to seal the surface. For example, the Epoxidharz L system by R&G has such a certificate. https://www.r-g.de/en/art/100110

The Mould should be printed with a lot of walls and strong infill.

I used the 0.2mm quality setting with 5 perimeter and 10 top layers.

Working with Carbon Fiber is dangerous. Always wear proper PPE!

Tags