M6/M8 v-slot 30x30mm Aluminium Extrusion Profiles.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
M6/M8 nut holder for 3030 V-slot: M8 supports M6 in wide slot for a solid, safe joint.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 14
- Makes
- 0
- Views
- 59
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Share Alike
CZ
Profil 3030 má širokou drážku a samotná matice M6 jí může projít, takže spoj není dostatečně opřený a může se vymačkávat. Proto používám nízkou matici M8 jako opěrnou „podložku“: v drážce dobře sedí, zvětší dosedací plochu a zajistí pevný a bezpečný kontakt. V držáku jsou nad sebou dvě nízké matice (M6 + M8), takže lze použít M6 i M8 (jen je potřeba mít správnou délku šroubu pro zvolenou variantu).
EN
3030 profiles have a wide slot and an M6 nut can slip through it, so the joint isn’t properly supported and can deform over time. That’s why I use a low-profile M8 nut as a support “washer”: it seats nicely in the slot, increases the contact area, and provides a solid and safe connection. The printed holder stacks two low-profile nuts (M6 + M8), so you can use either M6 or M8 (just make sure the screw length matches the chosen setup).