1 / 3
Ikea 365+ Lid Holders for cabinet doors or walls — image 1
1 / 3

Ikea 365+ Lid Holders for cabinet doors or walls

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Model information

Category
Kitchen
License
Creative Commons — Attribution — Noncommercial — Share Alike

Summary:

Ikea 365+ Lid Holder mountable on vertical surfaces, like cabinet doors, cabinet walls or walls in general. It includes complete holders for following Ikea 365+ container lids in variants for 4, 3, 2 or 1 lid:

  1. IKEA 365+ Lid, round/plastic (~14cm)

  2. IKEA 365+ Lid, square/plastic, small (~15cm)

  3. IKEA 365+ Lid, square/plastic, medium (~21cm) or IKEA 365+ Lid, square/plastic, large (~21cm) in vertical position

  4. IKEA 365+ Lid, square/plastic, size independent (left/right holders are split)

Not tested with bamboo lids (leave a comment if you checked it).

Holders are quite tight/gripy - enough for lids to not rattle when doors are closed or even slammed. You can make it tighter by using fuzzy skin (e.g. with settings like 0.4 distance/0.1 thickness), but I found it unnecessary.

Content/files:

  1. Ikea 365 Lid Holder BambuStudio.3mf (saved using Bambu Studio 2.5.0.66, tested with OrcaSlicer 2.3.2-Beta2)

    1. Plates 1-2: round lid, versions for 1-4x lids, depths:  18mm, 34mm, 50mm, 65mm.

    2. Plates 3-4: square small, 1-4x, depths: 19mm, 35mm, 52mm, 68mm

    3. Plates 5-6: square medium, 1-4x, depths : 19mm, 35mm, 52mm, 68mm

    4. Plates 6-7: square, split, 1-4x, depths : 19mm, 35mm, 52mm, 68mm

  2. Ikea 365 Lid Holder STLs.

    1. STLs for all sizes for connected/complete holders.

    2. Note! For split holders only left holders are provided - copy and mirror in your slicer to get right ones.

Recommended material:

Anything should work (maybe except of flexibles/TPU?).

Recommended slicing settings:

2x wall, 15% infill, you know - the defaults. Use auto-orientation.

Ok, maybe for round holders make sure your bridge settings are fine, it is not a long bridge, but it will be visible if it fails. If unsure use 0.95 or your normal flow for Bridge Flow setting.

Assembly instructions:

Use strong adhesive. Typical dual-sided "nano" tape should work fine, lids are rather light.

For split parts consider putting the lid into holders and stick it to wall/doors while holding all three things together, so that they are properly spaced after taping (or measure and mark). I use both connected and split models (that I made earlier), both should have enough surface for proper amount of tape, but if you are unsure of your tape or don't want to play with holding 3 things at once - use connected models.

Tags