Carrera 132 Porsche 911 GT3 R (922) Rear Wing / Spoiler / Heckspoiler 1:32 Slotcar
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A rear wing (spoiler) for the Carrera 132 (evolution or digital) Porsche 911 GT3 R (922) Slotcar.
- Rating
- 5 / 5
- Likes
- 8
- Downloads
- 144
- Makes
- 1
- Views
- 565
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Heckspoiler für Carrera Porsche 911 GT3 R (922)
im Maßstab 1:32
Das Modell ist von seiner Form nicht identisch zum originalen Spoiler von Carrera und auch nicht so filigran. Er wurde so konstruiert, dass er, insbesondere an den Steckverbindern, für den 3D Druck stabil genug ist ohne gleich zu brechen.
Es wird empfohlen den Spoiler wie auf den Bildern gezeigt zu drucken (Rückseite nach unten auf Druckplatte) damit die Streben möglichst stabil sind.
Nach dem Drucken ist etwas Schleifen mit feinem Sandpapier auf der Rückseite notwendig, wo die Stützen befestigt waren.
Ich habe die *.f3d Datei aus Fusion360 mit angehängt, falls man selbst noch Änderungen vornehmen möchte oder den Maßstab ändern muss.
*******************************************************************
Rear wing for Carrera Porsche 911 GT3 R (922),
Scale 1:32
The model is not identical in shape to the original Carrera spoiler and is also not as delicate. It was designed so that, especially at the connectors, it is strong enough for 3D printing without breaking easily.
It is recommended to print the spoiler as shown in the pictures (back side down on the print bed) so that the struts are as stable as possible.
After printing, some grinding with fine sandpaper is necessary on the back where the supports were attached.
I also attached the *.f3d file (Fusion360) in case you need some own modifications or you want to Change the scale.
*****************************************************************
Print Settings / Druckeinstellungen:
Material PLA or TPU
100% Infill
0,1mm Layer
Brim / Raft (for adhesion)
Supports on!