WPL D12 Rally Underfloor
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement part for older WPL D12 underfloor and lower arms mount when broken.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 20
- Makes
- 0
- Views
- 152
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Standard Digital File License
This is a rally WPL D12. The underfloor gets abused, So I made this as a swap in part for the underfloor to increase the ground clearance of the chassis.
This design fits first and second generation chassis.
There are two versions just in case you have broken the lower arm links. If you have done that you will have to remove them by cutting them flat to the chassis. Yes the actual underfloor clearance could be higher up but it will sacrifice the lower arm as the first point of contact and make it far more annoying to print when I can be just printing without faffing with supports.
Raw STLs, Not print oriented….although it should be obvious
P.S. Yes this is a 4 link conversion in the rear as well... : )