PTFE tube redirector for BBL P1S and P1P
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Pushes the PTFE tube down to stop it rubbing on the sharp edges of the case. Simple but effective.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 10
- Makes
- 0
- Views
- 111
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bambu Lab Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
This model redirects the PTFE tube from the extruder to stop it rubbing on the sharp edges of the enclosure and stop catching on the screws.
Why?
I was having a lot of issues with the PTFE tube rubbing on the top glass and “shedding” white dust through the printer that was almost impossible to clean up. To combat this, I built Sanja3D's riser, which solved that problem, but the PTFE tube now catches on the screws and runs along the sharp edge of the enclosure frame. This will probably happen with all risers.
Clips on the tube and chain didn't work well in all corners of the enclosure. I then tried installing a tube holder that clips on the extruder head, which worked really well until I tried stiffer filaments (like PLA Glow) that couldn't get around the tighter bend at the extruder unless forced through, which then caused shedding of the tube on the inside! sigh
I finally removed all the mods on the tube (I kept the riser because it's awesome!) and made this protector panel that screws into the side of the enclosure.
Installation:
Remove the M3 x 6 course thread screw from the top right corner of the enclosure. Place the protector panel with the hole lined up with the screw hole and secure with a M3 x 8 screw. I found the exact screw required in my parts box - it came with the scraper accessory kit, which I never used. It's a M3 x 8 course thread (I have put a link to the correct screw in the bill of materials section above).
Notes:
I don't know if this fits without a riser (it might be too tall) - if you print it and it works for you without a riser, and if it helps with the lid scraping at all, please help the community by letting us know in the comments section, and I'll update this description accordingly.
I printed mine in PETG as I do occasionally print high temp materials, but you can decide on the filament to use based on what maximum chamber temperatures you're likely to use.
Don't forget to check out other useful models (like my skinny dry box), in my profile!