Forced Air Vent Deflector
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
After setting up my 3d printers, I discovered they were in the direct line of fire from my forced air system which I…
- Rating
- 0 / 5
- Likes
- 43
- Downloads
- 223
- Makes
- 0
- Views
- 1,570
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
After setting up my 3d printers, I discovered they were in the direct line of fire from my forced air system which I wasn't crazy about. I designed a simple shroud to deflect all air the opposite direction so my prints aren't receiving any extra cooling.
I used a .375in / 9.53mm diameter and .06in / 1.53mm depth neodymium magnets purchased from Home Depot to attach the deflector to the vent. They fit tight enough to just pressure fit but I super-glued to be extra sure.
Print Settings
Printer Brand:
Ultimaker
Printer:
Ultimaker 3 Extended
Rafts:
No
Supports:
No
Resolution:
.3
Infill:
20%
Notes:
Higher resolution would have wound up with a better curve but I didn't really care enough.rnrnPrinted with the flat side down so no supports would be necessary.
Category: Household