Slim Rostock Max v3 Fan for 713Maker Mounts
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
After upgrading to the 713Maker mount (http://713maker.com/mounts.html) for my E3Dv6, I found that the original slim…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 6
- Makes
- 0
- Views
- 167
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
After upgrading to the 713Maker mount (http://713maker.com/mounts.html) for my E3Dv6, I found that the original slim fan shroud was too small. I remixed Noircogi's design to be both longer so it'll reach the print area, and added a gap in the middle of it to allow the PCB to sit in the gap. This results in a taller fan duct, and kind of works with autoleveling if you get them on straight and do a good job wiring. This is a WIP, as I would have brought the exhaust down lower but I didn't want to have to cut the tabs off of the effector - something which may eventually be required.
Category: 3D Printer Parts