Slim Rostock Max v3 Fan for 713Maker Mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
After upgrading to the 713Maker mount (http://713maker.com/mounts.html) for my E3Dv6, I found that the original slim…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 166
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
After upgrading to the 713Maker mount (http://713maker.com/mounts.html) for my E3Dv6, I found that the original slim fan shroud was too small. I remixed Noircogi's design to be both longer so it'll reach the print area, and added a gap in the middle of it to allow the PCB to sit in the gap. This results in a taller fan duct, and kind of works with autoleveling if you get them on straight and do a good job wiring. This is a WIP, as I would have brought the exhaust down lower but I didn't want to have to cut the tabs off of the effector - something which may eventually be required.
Category: 3D Printer Parts