1 / 11
BME/BMP280 Housing
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
There are plenty of these available but my design holds the module tightly inside the housing. In addition, the single screw hole is through and through so it's possible to use the same M3 bolt to hold the housing together and secure it another board with a standoff.
If you find your BME280 board is thicker than 1.5mm just sand down the plastic standoff inside the top piece.
I printed this using ZYLtech Matte Red ASA on my Ender 3 S1 Pro with a 0.4mm Diamondback nozzle at 0.2mm layer height. I used ASA as this will be monitoring conditions in a DIY filament dryer that will reach 65C.