1 / 4
Outdoor Low Voltage 12V Bollard-Style Pathway Light — image 1
1 / 4

Outdoor Low Voltage 12V Bollard-Style Pathway Light

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

An outdoor pathway light that utilizes 12V MR16 bulbs

Rating
0 / 5
Likes
7
Downloads
16
Makes
0
Views
168
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

FOREWORD

We recently moved into a house that had these metal pathway lights surrounding our pool deck. Well, over the years, a few may have been launched into the lawn from the snowblower.... or possibly hit with the lawnmower after a dog knocked it into the lawn and buried with leaves. Unfortunate. I modeled up a replacement that closely resembles the metal and glass originals and is brighter than the glass original. This light was only tested with the LED 5W MR16 bulbs, and I am unsure if this light will handle the heat from a 20w halogen MR16 bulb.

SETTINGS

I printed the grey pieces in ASA to help with longevity in direct sunlight. I used a 0.6mm nozzle and a Flashforge 5m (with an enclosure and HEPA filter/fan upgrade) with scarf joints to provide a smooth exterior.  For the grey cap, it could benefit from a 0.4mm nozzle, but I chose to print those with a 0.6mm nozzle to keep the texture consistent, except for a few minor print defects towards the top of the half sphere. No supports were needed.

The clear "glass" section was printed in transparent PETG with the cone closest to the print bed. I was able to significantly slow down print speeds to gain a more transparent end product. I left off scarf joints as this significantly decreased the transparency, and aligned the seam with a seam gap of 0mm and used a 0.4mm nozzle. Again, no supports were needed.

The stake I printed in Black ASA with a 0.4mm nozzle, which seemed to have some structural issues when printing vertically. I would recommend printing this item horizontally with supports. However, during modeling, I noticed the high structural integrity of printing vertically with Black PETG, which can be a sufficient alternative to printing horizontally. This model was printed with supports and with scarf joints disabled/ seam gap of 0mm.

I also included the gasket for the stake that I printed in grey TPU 95A (as I still don't want to open my Black TPU filament yet). I used the flash print variable layer height feature, but this is optional, as a few got printed with stock settings and still served the purpose. 

REQUIRED PARTS

This item requires a MR16 LED light and a MR16 Lamp Socket, as well as 2X small coarse thread screws to hold down the lamp socket, all of which can be easily sourced. 

LEAVING COMMENTS

The tolerances on the cap to glass are made to be snug, and I found that the first layer is sometimes a bit thicker, which can interfiere with proper fitment. I was able to sand down the edge of the glass closest to the cone to account for this. 

Again, tolerances of the glass to the tube are made to be snug, and due to the thin nature of the glass, in order to remain transparent, it can be tricky to slide the glass into the tube. I found that patience solves this issue, but I will provide the F3D file for anyone who wishes to adjust this. 

Tags