Sovol SV08 9mm Gantry (on top) *not tested yet*
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Modified motor mounts and xy joints for 9mm belts with double shear support
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 17
- Makes
- 0
- Views
- 230
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
CHECK OUT MY NEWER AND PROPER VERSION HERE!
PARTS NOT TESTED
all parts got "taller" for the additional height needed for the bigger belts - so not modified in bot directions to keep the belts kinda centered
i'm working on a proper mod but it will take a little longer
so if you plan on doing it properly, wait for the other version
the gantry parts are a remix from iEBPO - could not add it to this post because there would'nt be a fitting license - i think it makes more sense to put all the parts in here instead of splitting them and create possible more confusion
the parts are modified to use 5x35mm pins where idlers or pulleys are used
make sure your printer and filament are calibrated so the pins have a snug fit!
the motor mounts have a built in double shear support for F695ZZ bearing
motor with longer shafts are required!
the motor mounts and xy joints(not the belt tentioners) all use heat inserts no m3/4 nuts
Print Settings(voronish)
ABS or ASA
4 walls
4 top & bottom layers
35% gyroid infill
print all of my modified parts as oriented
supports are needed for the xy joints and the motor mount tops
BOM
qty | description | link * |
|---|---|---|
2 | motor | |
2 | ~4m belt | |
10 | 5x35mm pins | |
2 | 20 tooth motor pulley|bore 5mm| belt width 9mm | |
2 | 20 tooth pulley|bore 5mm| belt width 9mm | |
12 | no tooth pulley|bore 5mm| belt width 9mm | |
2 | F695ZZ bearings | |
12 | m4x40 bolts | |
m3/m4 heat inserts |
can't tell the right amount and length of all other bolts right now but a bunch of the original ones are used
i would recommend get a m3/m4 bolt set with different lengths like this one
to connect the new motors to the basic wiring the pins net to get figured out
the cables can be connected with a new connector or soldered
when using connectors(jst ph 2.0) get yourself a pair of wire strippers and crimpers
*all product links are affiliate links - i get a small kickback when you buy from these links with no extra cost!