Walther P.38 airsoft pistol air piston replacement fix
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement air piston for Walther P.38 airsoft pistol made by Umarex.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 32
- Makes
- 0
- Views
- 596
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Sports
- License
- Creative Commons — Attribution — Share Alike
This is for manual version of the pistol, not for CO2 cartridge version.
How I printed it
I printed in PETG and ASA, both work. I think ASA may work for longer, but that's just my tip. Printed in models original orientation through 0.4mm nozzle in 0.2mm layers with supports under the main cylinder and under the lip (either forced or auto-generated).
A bit of background
Friend of mine approached me if I could make him a replacement air piston for his Walther P.38 airsoft gun made by Umarex. The pistol replica is circa 2010-2015 model, I don't know if there were any more/different models through the time.
It was quite a challenge. The original piston broke at the lip where trigger mechanism holds it in "ready to fire" position - the lip was gone, teared away with part of the piston. I didn't have the lip available to me, so I had to come up with something by myself. My friend also has Colt 1911 airsoft gun so we had a look at the mechanism there and somewhat started from there.
I went through a few iterations before getting the final design.
First iteration had too small inner hole and thus didn't work at all. Second had the lip too short and didn't engage with trigger mechanism at all. Third was first that "worked", but the lip got teared away just as on original piston - the tear was completely aligned with the original as you can see on one of the images. I knew I have to employ some strengthening which I did by giving it a little chamfer. On fourth iteration the main cylinder stayed intact, but the lip got teared away at the place where chamfer ended.
Fifth design was nearly final one - I made the lip 2mm thick (sticking out of the piston, which doesn't limit the gun mechanism in any way) and also misaligned the inner part of outer cylinder so it has stronger wall where the lip is and thinner on the other end. I printed this iteration in PETG and ASA, both worked but you had to employ quite some force on the trigger to actually fire the pistol, it was even worse with ASA.
So it came to the sixth and final iteration, where I shortened the lip a bit which made firing the pistol a bit easier. It could probably be shoretened even more, but given my friend doesn't shoot the gun often, this will do. If you are printing this and find it too hard to fire, try chopping off 0.2-0.5mm of the lip in your slicer.