Bahtinov mask for Sky-Watcher BKMAK 150
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€4.00 – €4.89 net (excluding VAT)
For file: bahtinov-2_0.4n_0.25mm_PLA_MINI_4h3m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €4.45 excluding VAT (range midpoint).
- Weight reported by the author
- 64 g
- Print time reported by the author
- 4.05 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is my remix of Bahtinov mask dedicated to Sky-Watcher BKMAK 150 telescope.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 18
- Makes
- 0
- Views
- 84
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Physics & Astronomy
- License
- Creative Commons — Attribution
I wanted to have the Bahtinov mask for my MAK 150 and couldn't find one, so I made my own.
Based on the original, I have set it to be 175mm external wall diameter (part going into telescope's tube) and have 8mm border. I have added small protrusions for better fit. I also added two handles so it's easier to remove. My first version (on the photos) was printed without these and I still can take of the mask without problems, so it's a bonus.
As I have Prusa Mini+, I have prepared a project with border cut so it fits the printing table. It has also disabled skirt. Of course there is also full model for bigger printers.
Printed with PLA on draft settings and it is good enough. I just had to make sure, that whole table is covered with glue because there are a multiple outlines at the start and its easy to lose a few edges.
Thanks to the Author of original scad file. I have attached my modified version. Code is for sure far from perfect - I have combined original one with changes supported by AI and my poor imagination (AI didn't get original code, I just asked questions and fit the outputs to base design).