Minimalistic Post-It and Pen Organizer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Minimalistic Post-It and pen organizer.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 12
- Makes
- 0
- Views
- 84
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Put this together in TinkerCAD after not being totally happy with most models I'd seen.
I use the 76 and 50 mm square Post-It notes on a daily basis for work- as well as a few select pens. Fits 7 Post-It pads and a stack of the smaller squares.
No supports needed!
At 15% infill takes around 60g of filament with about 1 hour 45 min print time.
I added a slot to house a template like the checklist template from @PhiRequiem:
NOTE: The dock for the templates was a little too snug on my first go. I added 1mm to the width of the slot but I did not test/reprint to verify!!! (I just resized the checklist template, taking off .5mm so it would fit my first print of the model).
Happy printing!