Minimalistic Post-It and Pen Organizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Minimalistic Post-It and pen organizer.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 83
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Put this together in TinkerCAD after not being totally happy with most models I'd seen.
I use the 76 and 50 mm square Post-It notes on a daily basis for work- as well as a few select pens. Fits 7 Post-It pads and a stack of the smaller squares.
No supports needed!
At 15% infill takes around 60g of filament with about 1 hour 45 min print time.
I added a slot to house a template like the checklist template from @PhiRequiem:
NOTE: The dock for the templates was a little too snug on my first go. I added 1mm to the width of the slot but I did not test/reprint to verify!!! (I just resized the checklist template, taking off .5mm so it would fit my first print of the model).
Happy printing!