1 / 5
Cartographer Carriage for MadMax and Dragonburner — image 1
1 / 5

Cartographer Carriage for MadMax and Dragonburner

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Allows for a cartographer sensor on the carriage alongside the dragonbrick toolheads on MGN12H rails.

Rating
0 / 5
Likes
11
Downloads
48
Makes
0
Views
349
Reviews
0

Updated at source:

Model information

License
GNU General Public License v3.0

I wanted to run a shuttle that contained the x endstop and z probing independent of the toolheads on a madmax system. I was also having trouble getting the toolhead probe working reliably enough and this was an easy way around that.

The carriage contains 2 holes on the bottom to mount a cartographer or beacon probe by threading the screws into the plastic. It also contains a channel up through the center to route the cable and x endstop cable (if you'd like) out the top to avoid wacky umbilical setups. 

I'm using this with a low profile cartographer v3 but any model should work.

The design puts the probe at 2.8mm above the nozzle and 24.4 mm behind using a dragonbrick setup.

PLEASE NOTE: Due to the proximity of the cable to the rear of the attached toolhead a tool that has a motor or controller protruding from the rear may run into the cable.

The design was confirmed to interfere with an anthead tool head running a controller at the rear. If "bricked" and running a controller in the front the design may work.

Requires another magnet retention screw and nut, duplicating the one in the center.

Tags