Cartographer Carriage for MadMax and Dragonburner
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Allows for a cartographer sensor on the carriage alongside the dragonbrick toolheads on MGN12H rails.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 349
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
I wanted to run a shuttle that contained the x endstop and z probing independent of the toolheads on a madmax system. I was also having trouble getting the toolhead probe working reliably enough and this was an easy way around that.
The carriage contains 2 holes on the bottom to mount a cartographer or beacon probe by threading the screws into the plastic. It also contains a channel up through the center to route the cable and x endstop cable (if you'd like) out the top to avoid wacky umbilical setups.
I'm using this with a low profile cartographer v3 but any model should work.
The design puts the probe at 2.8mm above the nozzle and 24.4 mm behind using a dragonbrick setup.
PLEASE NOTE: Due to the proximity of the cable to the rear of the attached toolhead a tool that has a motor or controller protruding from the rear may run into the cable.
The design was confirmed to interfere with an anthead tool head running a controller at the rear. If "bricked" and running a controller in the front the design may work.
Requires another magnet retention screw and nut, duplicating the one in the center.