1 / 15
The Urban Prop: Baja Squadron Fog Mount (LR3/LR4/L320) — image 1
1 / 15

The Urban Prop: Baja Squadron Fog Mount (LR3/LR4/L320)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

The Urban Prop: Baja Squadron Fog Mount (LR3/LR4/L320) Ditch the dim factory fogs for the off-road industry standard.

Rating
0 / 5
Likes
2
Makes
0
Views
188
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Standard Digital File License

The Urban Prop: Baja Squadron Fog Mount (LR3/LR4/L320)

Ditch the dim factory fogs for the off-road industry standard. This mount allows you to bolt Baja Designs Squadron (Sport or Pro) pods directly into the factory 100mm fog light locations. No bumper cutting required.

The Design

  • Hardware Reinforced: Each mount uses 3x M5 x 20mm bolts and nuts as the core assembly method. This provides superior structural strength and vibration resistance over simple snap-fits.

  • Recessed Aesthetic: Engineered to sit slightly behind the bumper trim for a clean, integrated look that follows the Land Rover's lines.

  • Trail Tested: Designed for and used on technical trails; printed in ASA for maximum heat and UV resistance.


Snap-Install Instructions

Assembly

  • For the two-piece version, slide the inner light cradle into the outer shroud.

  • Align the holes and insert your 3x M5 x 20mm bolts.

  • Thread the M5 nuts onto the backside and tighten until the assembly is rigid.

Mount the Light

  • Secure your Baja Designs Squadron pod into the cradle using the hardware supplied with your lights.

  • Ensure the Baja logo is oriented correctly.

Bumper Install

  • Remove the factory fog light housing (access via the wheel well liner).

  • Slide the new assembly into the pocket from the front and secure it using the OEM factory screws.

  • Plug in your wiring (H11-to-Baja adapter recommended for a plug-and-play setup).


Bambu Lab X1C Settings (ASA Mandatory)

  • Wall Loops: 6 (For off-road durability)

  • Infill: 40% Gyroid

  • Temp: 260°C–270°C Nozzle / 100°C Bed

  • Pro-Tip: Preheat your chamber to 40°C+ and keep the door closed until the print is fully cooled to prevent layer splitting.


Terms of Use

This file is for Private Use Only. By downloading, you agree not to redistribute the digital files or sell physical prints of this design. I offer professionally printed ASA mounts for $80 shipped (CONUS)—message me if you'd rather buy a finished set!

Tags