SEN66/XIAO ESP32 Air Quality Monitor Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A case for an air quality monitor created by pairing a Seeed Studio XIAO ESP32 and Sensirion SEN66 air quality sensor.
- Rating
- 5 / 5
- Likes
- 23
- Downloads
- 165
- Makes
- 2
- Views
- 880
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
A basic case for an ESPHome air quality sensor I made using a Sensirion SEN66 and XIAO ESP32C3. There are other cases for this combo out there, but the ones I saw incorporated a screen which wasn't relevant to my use case as I'm just using these to feed data into Home Assistant. It should be noted this will work with any SEN6x sensor as they all have the same form factor.
This design is quite basic as I used this as a learning opportunity for 3D design. I figured I'd share this if someone was looking for a simple, basic design. The bracket is adapted from the one Sensirion provides. There is also an optional "Sealing foam" that can be used. I printed that in TPU but the rest of the print was done with 3D Fuel PCTG, though PETG would most likely work fine too. PLA might have some issues as the sensor snaps into the bracket as a somewhat tight fit and the legs may snap off the bracket.
I've included two lid options. I realized I inadvertently created a bit of a speaker with the closed lid and it caused the SEN66 to generate a faint low hum while operational. It was really only noticeable from a few feet away when the room was totally silent, but I still didn't like it. The slotted lid resolves this issue. If the sound doesn't bother you, the solid lid will work fine.