1 / 3
Holder table legs IKEA ADILS
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed this table leg holder to store the legs of a side table. Two holders are required to store four IKEA ADILS table legs. I mounted the holders under the tabletop to make storage as easy as possible.
I printed them in PLA using a 0.4 mm HF nozzle on my CoreOne+ with a layer height of 0.15 mm, 15% infill, and 4 perimeters. I used organic supports to support the bore hole. The print uses approximately 39 g of filament and takes about 3 hours.