Stand and Cablemanager for Multimeter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I already had built this box. Now I added cable management and an integrated 45° stand.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 12
- Makes
- 0
- Views
- 105
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I already had built this box. Now I added cable management and an integrated 45° stand.
Cables flying through the box, jamming outside edges. WTF! Cable management lid is held by 3x3 ø6x2mm Neodyms.
With the 45° stand I don't need to trake the multimeter out of the box that often, which makes working much more convenient! Joints are 25-30mm M3 dowel pins. I printed in PETG, so you may thoroughly drill the hinges with 3mm drill bit. Be careful, take your time. The retainer (red) is held by a piece of filament ø1.74mm. Check the holes before installing, a ø2mm drill bit can do mirecles.
Both parts will be glued on the bottom of the box.
There is always room for some improvement!
Here the original box:
Explore my other Printables: https://www.printables.com/de/@Tritschi