Stand and Cablemanager for Multimeter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I already had built this box. Now I added cable management and an integrated 45° stand.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 105
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I already had built this box. Now I added cable management and an integrated 45° stand.
Cables flying through the box, jamming outside edges. WTF! Cable management lid is held by 3x3 ø6x2mm Neodyms.
With the 45° stand I don't need to trake the multimeter out of the box that often, which makes working much more convenient! Joints are 25-30mm M3 dowel pins. I printed in PETG, so you may thoroughly drill the hinges with 3mm drill bit. Be careful, take your time. The retainer (red) is held by a piece of filament ø1.74mm. Check the holes before installing, a ø2mm drill bit can do mirecles.
Both parts will be glued on the bottom of the box.
There is always room for some improvement!
Here the original box:
Explore my other Printables: https://www.printables.com/de/@Tritschi