Lock Pick Caddy
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Rotating holder for lock picks.
- Rating
- 5 / 5
- Likes
- 24
- Downloads
- 99
- Makes
- 0
- Views
- 670
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution
A variant of my Rotating Sharpie Caddy designed to hold lock picks. Has slots for five Peterson picks and seven Multipick picks. The thinner Multipick slots do a fine job of holding top of the keyway tension tools.
Design
Parametric design done in Fusion 360. Height, pick angle, wall thickness or base-to-caddy clearance are easy changes. Changing the number or sizes of slots are doable but require a bit of work. If you modify it please share your make so I can see what you did with it!
Printing
Prints in two pieces. No supports needed. The clearances on the pivot are fairly tight so I would stick to 0.4mm nozzles with a layer height of 0.2mm or less. The base should use either 100% infill or enough vertical perimeters to remove the need for infill in the pivot pin. I've printed these in both PLA and PETG