Stealth Airtag Spacer for Canyon Cockpit H11, H31, H36, CP30, CP0030 CX or CP10
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Here my final version of integrating an Airtag device into my roadbike.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 17
- Makes
- 0
- Views
- 182
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
Problem:
Airtag inside the Carbon frame did not work that well because of Mr. Faraday.
There are some other good places to put one such as under the saddle or integrated inside a water bottle holder.
If I were a thief though those are exactly the first places to look for one.
Solution:
I combined the smallest Airtag capable device I could find and integrated it inside the spacertower. Depending on your cockpit situation the spacer lie either on top the cockpit or under it. For it to work, the spacers need to be stacked all together, so all either on top or all spacers under it.
I made it a two part design allowing it to seal watertight with an Oring.
For my bike I used the 22mm version, for my brother I made a 27mm version. If you need it custom, you can write me and I can adjust it. Its very easy.
Parts and Tools you will need:
Iphone
Inner and outer part printed out in black PETG, ASA, Nylon, etc.
32x2 or similar sized O-Ring
„Azok stamp“ (found on aliexpress or tvcmall)
Grease
small philips head screwdriver
2,9mm screw for wood or sheet metal
Assembly:
Pair Azok stamp with your phone by following the instructions
Remove the pcb by removing battery first, then unscrewing the pcb
Install Oring and grease it really well
Also grease the inner contact points of the two parts
Install the Azok PCB together with the battery
Push two parts together
If you need to disassemble it, screw in the screw and pull on it.