Prototype Sliger CX2177A 2U rack case rear rack ear support
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Rear support for Sliger CX2177a in short depth rack
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 5
- Makes
- 0
- Views
- 37
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Public Domain
I only printed a skeletonized version of this to verify dimensions and fitment. Dimensions are correct but I didn't do anything to optimize the model further. The plate is 5 mm thick the rack ear is 3.5mm thick. Overall footprint is 87.88 x 170.2 mm. Holes are made to fit M4 screws that the CX2177a uses for rack mounting. This was for a 4U Gator Case that has an 18" gap between front and back of the rack posts. To use this model you will need a rack that has removable sides to screw it to the case. I think it should be strong enough to print in PETG as is since the front ears hold most of the weight. I don't particularly plan on revisiting this design since I went a different route.
You will need some M4 8 mm long screws to mount this. 8 is a little short as it will only give 3 mm of thread engagement out of the 4 mm recommended but they don't make a 9 mm long screw. Might want a brim since there isn't a lot of contact area. I would recommend printing on edge for best results.