1 / 1
E3NG Toolhead Base MicroSwiss
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Two heat insert M5 and one M6 are used. The belt retainer of the micro swiss must be cut off that it can be mounted. The X-endstop was move more to the side. This leads to a smaller print area and need to be adjusted in the firmware.
Firmware adjustments:
Printable Area: 210 mm x 210 mm
BLTouch Offset: X -45 mm; Y -10 mm
Probing Area: 165×165
It is a first issue of this design modification, so if you have any troubles or change ideas, please feedback.