1 / 3
cyclone 120 (big time credit to JN printing) — image 1
1 / 3

cyclone 120 (big time credit to JN printing)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

cyclone. 120 =D 125 and P50 coming possibly soon!

Rating
0 / 5
Likes
5
Downloads
10
Makes
0
Views
147
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

big time credit goes to JN printing because i got the idea from his model and use some of his parts in it:

(i had to put a different model because i can't paste the original link)

parts used by me that were his:

half of stator/horn ring

motor hat/top

INSTRUCTIONS AND PARTS LIST

parts needed:

motor cover

horn ring

chopper

intake

HARDWARE:

hot glue gun with hot glue sticks (or soldering iron)

130 motor: 130 DC Motor 3V-6V 27000 RPM Miniature Electric Motor for DIY, Robotics, and Remote Control Toys - Compact and Easy to Install (20 Pcak - Amazon.com

(best on 3V)

wires i used: (not required but recommended) TUOFENG 28awg Wire Flexible Silicone Wire,28 Gauge Tinned Copper Wires Silicone Rubber Insulated (6 Different Colored 43ft Each)(OD: 1.2 mm) Stranded Wire Hook up Wires - Amazon.com

INSTRUCTIONS

 first take your motor and make sure the shaft is good to fit on the chopper.  

next take your horn ring and motor and press the motor into its holder on the horn ring and glue if needed

once you have that done wire the motor and feed the wires through the hole in the hat.

and then press the hat into the indent for it and glue or solder

once you have that done press the chopper onto the motor shaft and then glue the intake on carefully.

Tags