1 / 8
Meshtastic Outdoor Parabolic Reflector - Alfa 915 Antenna — image 1
1 / 8

Meshtastic Outdoor Parabolic Reflector - Alfa 915 Antenna

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A simple parabolic reflector for Meshtastic 915MHz and or 868 MHz Radios.

Rating
3 / 5
Likes
29
Downloads
88
Makes
0
Views
1,523
Reviews
1

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution

A simple broad parabolic reflector for Meshtastic 915 or 868 MHz. This has been tested with the Alfa 915 N Connector antenna and has minimal impact on SWR. 

Front to back gain is around 15 dB with almost no difference in signal strength from 45 to 90 degrees off axis of the center. There is a sharp area of gain directly in front of the reflector. 

Use this reflector if you are on the edge of your mesh and need a little extra signal towards your nearest nodes. This reflector will focus your signal in the direction you want without creating a narrow beam that misses other nodes. 

The reflector is designed to pivot around your N connector antenna so you can aim the reflector without having to aim the whole node. It can pivot 180 degrees depending on your enclosure design. 

Assembly Instructions:

  1. Print all parts in PETG. 0.4mm nozzle, 0.2mm layer height, 5 top, 5 bottom, 5 perimeters. 

  2. Install rods in the holes. Use CA Glue to secure them in place. 

  3. Cut 1/2" hardware cloth to fit. 16 squares wide by 15 high. You can make it bigger for a more focused beam. 

  4. Centre the centre square on the centre rod and use tie wire (comes with your bundle of hardware cloth) and pliers to secure the hardware cloth to each rod at top and bottom. Make sure the hardware cloth conforms closely to the curve.

  5. Fit the centre hole over your N connector bulkhead. 

  6. Attach your antenna and screw it down tight but not too tight. Use the provided printable washers if needed for spacing. Scale up in the Z direction to fit your setup. 

  7. Use the Bottom Plate to fill the gap between the Parabolic Base and your enclosure. Scale the Z height in your slicer to get a tight fit. There are 2 options. Glue plate for gluing down with CA glue and No Glue for use with double sided Gorilla Tape. For either option glue the plate to the bottom of the Parabolic Base with a little CA Glue. 

  8. Glue on the optional pointer which can help with aiming your reflector.

  9. Set up your node in its permanent location. Using the Traceroute function aim your reflector to get he best signal to your desired node(s)

  10. Once you have it all positioned perfectly squirt a bunch of CA Glue down the glue hole on top of the Parabolic Base and glue in the Glue Cap. The glue will flow through the glue channels and create a permanent bond that does not stress your antenna mount due to wind loading. Watch for drips and clean with a paper towel. CA Glue Accelerator really helps here. 

  11. Congrats that's it. 

There is also a collapsible version that can use 200mm M3 threaded rod in place of the plastic rods and mesh. Yes, the vertical rods can make an equivalent reflector all on their own without any mesh needed. Use M3 nuts and threadlocker on both sides of the Parabolic Base and Top Rail parts to secure the assembly. See the parts with the M3 suffix. 

Tags