MMU2S FINDA Wire Support
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.46 – €0.56 net (excluding VAT)
For file: Fiament Sensor Support_0.2mm_PETG_MK3SMMU2S_41m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.51 excluding VAT (range midpoint).
- Weight reported by the author
- 3 g
- Print time reported by the author
- 40.8 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Support for the wire from the FINDA sensor on the MMU2S to the main PCB case.
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 46
- Makes
- 2
- Views
- 627
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution
I had some problems where the senor wires on my MMU2S would weaken over time through the back and forth movement. So Here is a support for said wire using a piece of 1.75 mm filament to support it.
There are two options for mounting the end of the support. I just super glued the last connector on the chain to the MMU2S control board cover. There is a end piece with a frame for the connector but I didn't find that it worked so well.