Better X, Z brackets for (Un)original Prusa Heated Drybox
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Allow easier assembly of electronics
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 13
- Makes
- 0
- Views
- 123
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
When I assembled my heated drybox I've used not heat enough resistant materials in a few places. So after several months of usage some parts warped and I had to resolder and reassemble the drybox. When I remembered how difficult it was to solder the original one I decided to remix the brackets to make the soldering and assembly process easier.
In this remix the mounts for the Arduino board, DC-DC converter, MOSFET and humidity sensor are click and hold style. Brackets don't force you to solder in a particular order and can hold electronics while you solder them in the bracket. Also the placement of the electronics is spread out to make the wire placement easier and as a side effect I didn't design for you can clip some wires in place.
Make sure to use a heat resistant material for printing. Regular PLA would not work even if you plan to use the drybox on lower temperatures.
Both brackets have a build in easily removable brim (the circles in the corners). It allows the parts not to detach from the bed while cooling.
