Better X, Z brackets for (Un)original Prusa Heated Drybox
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Allow easier assembly of electronics
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 123
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
When I assembled my heated drybox I've used not heat enough resistant materials in a few places. So after several months of usage some parts warped and I had to resolder and reassemble the drybox. When I remembered how difficult it was to solder the original one I decided to remix the brackets to make the soldering and assembly process easier.
In this remix the mounts for the Arduino board, DC-DC converter, MOSFET and humidity sensor are click and hold style. Brackets don't force you to solder in a particular order and can hold electronics while you solder them in the bracket. Also the placement of the electronics is spread out to make the wire placement easier and as a side effect I didn't design for you can clip some wires in place.
Make sure to use a heat resistant material for printing. Regular PLA would not work even if you plan to use the drybox on lower temperatures.
Both brackets have a build in easily removable brim (the circles in the corners). It allows the parts not to detach from the bed while cooling.
