Pot Lid Holder, fusion archive, parametric, sticky doubles-sided tape
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
No hole drilling lid holder specifically for your lids
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 6
- Makes
- 0
- Views
- 41
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
I've tried several lid holders and decided to build my own version.
This holder is mounted without screws via 1mm thick clear double sided mounting tape.
The model is parametric with really two parameters - holder inner length (set to lid diameter + a few mm of tolerance) and holder inner width (default one is ok for lids < 260mm, for bigger ones increase it a bit - smaller sizes would work, but then expect that the filament would bend and act as a spring a bit, so PTEG would be better than inflexible PLA).
To change these parameter in fusion type s/change parameters:

