Filament guide for IKEA Lack enclosure
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€4.87 – €5.95 net (excluding VAT)
For file: Just uploading the gcode / filament-guide-bottom_02mm_petg_mk3s_5h26m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €5.41 excluding VAT (range midpoint).
- Weight reported by the author
- 72 g
- Print time reported by the author
- 5.43 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A filament guide for IKEA Lack enclosure allowing the filament to smooth following the X-carriage while it moves along…
- Rating
- 4.806 / 5
- Likes
- 227
- Downloads
- 1,374
- Makes
- 34
- Views
- 7,437
- Reviews
- 36
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
A filament guide for IKEA Lack enclosure allowing the filament to smooth following the X-carriage while it moves along the X-axis.
Internal dimensions (5 mm width) allows use of ø4 mm PTFE tube from e.g. dry box to extruder.
Print instructions
Installation:
First measure where the filament enters into the extruder. It depends on how the printer is placed in the enclosure and is likely somewhat closer to the front than the back.
This will give the depth position of the filament guide, draw a thin line on top and bottom of the table. Make sure the lines is aligned.
Then mark the position for the four ø11 mm holes to be drilled, 2 on each top and bottom side of the table.
For the top part the distance (for hole centre) is 160 mm and for the bottom part it is 200 mm.
Drill the holes, but not through the table.
Then use a fine tooth saw to remove then part between the holes.
The table’s paper infill cut by a knife.
Verify the two part aligns when they are fitted into the table. The extrusion on the top part must fit into the slot on the bottom part.
When the alignment is verified the bottom part is attached to the table by two wooden screws.