GR86 / BRZ rear speaker mount for 5.25" speaker
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Plastic optimized print for the rear speakers on the gr86 / brz to mount 5.25" speakers
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 66
- Makes
- 0
- Views
- 352
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Share Alike
One piece reinforced rear speaker mount for the brz and gr86 chassis, should also work with frs and gt86.
This was used with some skar audio rpx525s without issue.
Mirror print for the other side!
I recommend using some foam tape at the backs as the mounting points are fairly small so there is not a lot of surface area to distribute the load.
This could also very easily be made flat and sent to a place like send cut send and have metal ones made, but I'm cheap.
Note this will not sit centered in the opening, also, unless you have an aftermarket amp that can up the rear gain there is little benefit to larger speakers in the back. They are also filtered at the head unit at least on my base gr86 so they will never see below maybe 300hz
Share your creations.