Dual Shock 4 Stand

Update (08.09.2024): I've made a one where controller sits better so it doesn't fall
Can be found here 

Attention:

This is not a perfect stand for your controller this is just for aesthetics look controller is not that stable on top of this

Here is a Dual Shock 4 Stand with Playstation logo

Update (11.28.2020):

Now there is two versions of independent logos one will sit flat with the stand and the other is going to stick out around 1mm

IG: @AfroPsycho

Note: This stand is not holding the controller that good so use it only for display

Print Settings

Printer:

3D4E 4Gen Pro 2R

Rafts: 

Doesn't Matter

Supports:

Yes

Resolution: 

0.3-0.1mm

Infill:

20

Filament:

ABG PLA

Red & Black

Notes:

You can use some support on the stand depending on your plastic cooling speed I preferred printing with supports

There is 2 versions of stand one is DS4StandLogoIndent which allows you to make it dual color

And the other one is DS4StandLogoExtruded which is a single print

Category: Organization