CarbonStar 200 Rear Cover
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A rear cover for the Apertura CarbonStar 200 telescope that doesn't fall off!
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 9
- Makes
- 0
- Views
- 67
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution
This design used snap clips that hold the cover in place rather than the compression fit the factory cover relied on (and didn't work especially when cold).
There are notches to make it easy to pop it out with a flat blade screwdriver or even a finger nail.
There is some play allowed for in the fit. If that bothers you just wrap a few pieces of stick on felt flocking over the edge that fits into the opening.
This stl is optimized for PETG HF on a Bambu Labs X1C using a super tack cool plate. I did have to slow the first layer down a lot to get a nice finish over such a large object. That could have just been my well used build plate. ymmv