Wall mount/hanger for Galaxy Star Projector/Night light
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Needed a way to mount my daughters night light projector, so I came up with this.
- Rating
- 5 / 5
- Likes
- 2
- Downloads
- 2
- Makes
- 1
- Views
- 43
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Open Community License v1
This hanger just slides over the end of the projectors stand and mounts on the wall, causing the projector base to sit flat, you still have the full range of motion offered by the projector for aiming.
You can stick it, or screw mount it with (holes are 6mm with 11cm CB, 4mm head) I was using screws then had to move it so used "Command Strips" to stick it on instead, and they've held great so far.
The projector we have is called "MERTTURM Galaxy Star Projector, 13 in 1 Home Planetarium Night Light" but it looks to be a clone, or has many clones of the same item so it should fit all of them too.
The max width for the projector base is about 106mm and the diameter should be 10mm or less to fit through the gap.
Prints flat on the base and enable supports (on bed only. Prints in about 20 minutes. Don't try to lower the infill, else you risk the supporting tabs breaking off and dropping your projector. Worked OK for my in PLA, maybe use ASA or PETG if you'd like it stronger. Mine has been hanging for a year now and the dimensions haven't changed.