Improved case for GM328A transistor tester (USB-C version)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A remix of the remix with improved lettering and optional model type and warning labels.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 29
- Makes
- 0
- Views
- 130
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
A remix of the remix with improved lettering and optional model type and warning labels. The lettering in the remix this is based on was slightly too small to print well using a 0.4 mm nozzle. This redesign uses larger letters and a different, more print-friendly font. There are two additonal variations of the top plate available, one with an embossed model name and one with the model name and a warning label ("Discharge Caps Before Testing!").
The original case offers a good fit. I would have liked to add some wider chamfers and to make some walls a bit thicker, but editing STLs is kind of a pain and this works well enough :)
Print settings
Layer height 0.2 mm
Line width 0.4 mm
4 wall lines
4-5 top & bottom layers
Supports enabled (build plate only)
Approximate print time @ 60 mm/s: Top 1:35 h each, Bottom 0:55 h