1 / 1
LGA 3647 Narrow Carrier Clip (CPU heatsink clip) (Narrow ILM) — image 1

LGA 3647 Narrow Carrier Clip (CPU heatsink clip) (Narrow ILM)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A bracket for mounting LGA 3647 CPUs (for coolers of the "Narrow / Rectangle" type) WARNING: CAD MODIFICATIONS REQUIRED

Rating
0 / 5
Likes
1
Downloads
36
Makes
0
Views
147
Reviews
0

Updated at source:

Model information

Category
Computers
License
GNU General Public License v3.0

WARNING:

The mounting holes are still a bit off, you must modify the CAD model yourself if you want to attempt this, as I no longer have the time to continue this project.  

Introduction

Based off DigiKey part 2299806-1. The original STP model was missing the holes and text, which I added back in.

Untested. Should fit but I'm unsure if the holes are the exact same dimensions, I've added an F3D file so you can edit this yourself. I'll print and test it if the cooler I ordered doesn't have this bracket included.

I couldn't find any other models of this so definitely better to make one than to waste $20 buying this piece of plastic. 

EDIT 1:

Printed it two times so far. First print was horizontal with supports on the bottom part, however it failed because most of the clips were either destroyed by supports or fell off. The top surface also had some weird artifacting. 

Second print was diagonal with the default support style (perhaps tree supports would've been better), this one turned out to be usable. I switched to 0.08mm layer height and printed it. Supports again destroyed the surface a bit, however this doesn't seem to be much of a problem. You can also lose some of the clips as long as it's not the two clips holding the CPU in place. Looks like this would work fine but I don't have the motherboard yet to test it. The design could probably also be improved since clips on the outer edges are prone to breaking, I'll probably try to increase their thickness in the future when I know that those changes won't prevent it from fitting the motherboard. 

As we can see most of the central processing unit did make contact with the heatsink even without tightening any of the screws. So this could probaby be used as-is. 

Tags