MESH NUGGET 2x2x3cm Xiao NRF Case for MeshCore and Meshtastic Nodes
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Tiny mesh node build that is above all else, very small.
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 32
- Makes
- 0
- Views
- 395
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
There's a lot of node builds to choose from out there. But what if you don't want any of those features like range or battery life and just want something really really tiny? Here is a piece of plastic you can slide over a Seeed kit and call it a node.
Features:
SMOL
Hours of battery life maybe
Battery switch
Necklace holes
Node specifications:
Size: SMOL (fits 2x2x3cm)
Cost: SMOL
Power Consumption: SMOL
Range: SMOL
Main Parts:
501225 110mAh 3.7v battery Scrap it from a vape ;)
Additional Parts:
1/2in or 10mm Heat Tape
Super Glue
Thin braided wire
Printing Instructions:
0.2mm nozzle is recommended and probably required.
Standard settings should be fine.
Layers are weak at this scale. Using plain pla and Tack-melting the weak points near the USB port and lid will help.
Fuzzy skin, textured plate, and gold silk pla for the ultimate nugget experience.
Assembly Instructions:
Remove the excess solder from the 4 unused pads on the lora board.
Cover the top of the lora board in heat tape to prevent shorting with the slide switch housing.
Bend the bottom pins of the lora board inward 90 degrees.
Adhere the lora ribbon antenna to the underside of the lora board, between the bent pins, pointing toward the back (opposite side of the usb port).
Shape the antenna's cable so that it coils up above the shielding.
Snip the wings off of the slide switch.
Bend the slide switch pins up at a 90 degree angle at the holes.
Super glue the slide switch to the heat tape on the lora board above the bare solder pads.
For wiring, the battery will need to go in with its terminals above the slide switch. Figuring out how to solder the wires to the battery pads on the nrf board and slide switch will take some creativity. There is a small space in the back for wire slack and the back half of the antenna.
Cover the battery terminals in heat tape to prevent shorting and tearing.