Extrutim DryBox -- spacer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a spacer that goes under the PC4-M10 if you're not using the flex cap
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 31
- Makes
- 0
- Views
- 167
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Open Community License v1
This is a teeny tiny addon to the:
I remixed the label holder into a spacer that goes in between the cereal box and the PC4-M10 if you're not using the flex cap. Because I found that without any spacer there was a bit of a gap (depending on the exact borehole).
It is based on the dimensions of the label holder (because I was lazy to iterate on it), but it really just uses a few of the measurements (see the f3d for details, if curious).
Print it on the back (lyin on the flat side with the PC4-M10 hexagon facing up. I know the orientation in the STL is wrong, but it was easier to copy the design this way.