Extrutim DryBox -- spacer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a spacer that goes under the PC4-M10 if you're not using the flex cap
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 167
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Open Community License v1
This is a teeny tiny addon to the:
I remixed the label holder into a spacer that goes in between the cereal box and the PC4-M10 if you're not using the flex cap. Because I found that without any spacer there was a bit of a gap (depending on the exact borehole).
It is based on the dimensions of the label holder (because I was lazy to iterate on it), but it really just uses a few of the measurements (see the f3d for details, if curious).
Print it on the back (lyin on the flat side with the PC4-M10 hexagon facing up. I know the orientation in the STL is wrong, but it was easier to copy the design this way.