1 / 4
ResMed AirFit P10 Headgear Clip — image 1
1 / 4

ResMed AirFit P10 Headgear Clip

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Replacement headgear clip for the older AirFit P10 CPAP mask.

Rating
0 / 5
Likes
3
Downloads
4
Makes
0
Views
73
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Backstory

The older ResMed AirFit P10 headbands have small Headgear clips that are easily lost or pop off.  This is an original attempt to re-create the clip so I can print when they get lost or break.

Print Recommendations


I printed it in PETG to make sure we have flexibility and strength. Print it flat with the cutout facing up, shouldn't need any support.  I did 100% infill since I needed it to be strong.  I did .2mm layer height since its pretty small.  I'd avoid using PLA, as it probably would snap easily.

Hardware/Assembly Information


It should work pretty much like the original, might need to pull a small part through before the rest will come through. Once you do it a few times, it should be flexible enough without needing to use a screwdriver or anything.

Usage Recommendations

This is still being tested nightly, adjustments might end up being made with gap sizing or the teeth.  

Tags