1 / 4
ResMed AirFit P10 Headgear Clip — zdjęcie 1
1 / 4

ResMed AirFit P10 Headgear Clip

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement headgear clip for the older AirFit P10 CPAP mask.

Ocena
0 / 5
Polubienia
3
Pobrania
4
Wydruki
0
Wyświetlenia
72
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Medical Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Backstory

The older ResMed AirFit P10 headbands have small Headgear clips that are easily lost or pop off.  This is an original attempt to re-create the clip so I can print when they get lost or break.

Print Recommendations


I printed it in PETG to make sure we have flexibility and strength. Print it flat with the cutout facing up, shouldn't need any support.  I did 100% infill since I needed it to be strong.  I did .2mm layer height since its pretty small.  I'd avoid using PLA, as it probably would snap easily.

Hardware/Assembly Information


It should work pretty much like the original, might need to pull a small part through before the rest will come through. Once you do it a few times, it should be flexible enough without needing to use a screwdriver or anything.

Usage Recommendations

This is still being tested nightly, adjustments might end up being made with gap sizing or the teeth.  

Tagi