1 / 2
Gardenhose reel handle
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The handle broke because the reel tipped over. So a good excuse for a 3d print
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 3
- Makes
- 0
- Views
- 40
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial
This is a replacement handle for a gardena reel system.
You need:
2 M10 bolts of 106mm long
3 nuts
2 washers.
4 3.5x25mm screws and a short piece of electrical tube for the handle.
For printing I used 30% infill 0.2 layer height. I used PETG. I would not recommend using PLA for this because in summer this will cause problems. For the axel I used supports, but it could be ok to print without support. I didn't test this.