1 / 30
Plateau Revopoint T 125 et plot de marquage 3D magnétique (magnet 6mm*3mm x 108 magnets) — image 1
1 / 30

Plateau Revopoint T 125 et plot de marquage 3D magnétique (magnet 6mm*3mm x 108 magnets)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Plateau 345mm pour plateau tournant revopoint T 125 avec plots de marquage 3D magnétique magnet 6mm*3mm x 108 magnets

Rating
0 / 5
Likes
5
Downloads
18
Makes
0
Views
104
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Plateau 345mm pour plateau tournant revopoint T 125 avec plots de marquage 3D magnétique

magnet 6mm*3mm x 108 magnets

Le plateau magnétique vient s'emboiter à la place du plateau d'origine sur la base motorisé du plateau revopoint T 125

Utilisation de 54 aimants diamètre 6mm pour 3mm d'épaisseur sur le plateau

Chaque plot de marquage a besoin de 3 aimants de 6mm*3mm

Ajout des marqueurs de 6mm sur le plateau et sur les plots de marquage

Pour assembler les aimants sur le plateau, veuillez respecter la même polarité afin d'avoir toujours le même champs magnétique.

Afin d'emboiter correctement les aimants sur le plateau magnétique, vous aider d'un réglet en métal pour aligner les aimants puis tapoter gentille ment avec un petit marteau pour enfoncer les aimants dans leurs logements.

Impression réalisé en PLA, mais le PETG est aussi une très bonne option (penser a mettre les supports pour les logements des aimants.

N'oubliez pas d'appliquer un peu de graisse lors du remontage du plateau sur la base.

PS : Ajouter si nécessaire une goutte de colle pour maintenir les aimants sur les plots de marquage



345mm Turntable for Revopoint T 125 with Magnetic 3D Marking Pads

108 Magnets (6mm x 3mm)

The magnetic turntable replaces the original turntable on the motorized base of the Revopoint T 125 turntable.

The turntable uses 54 magnets, each 6mm in diameter and 3mm thick.

Each marking pad requires 3 magnets (6mm x 3mm).

Add 6mm markers to the turntable and marking pads.

When assembling the magnets on the turntable, ensure the same polarity to maintain a consistent magnetic field.

To properly attach the magnets to the magnetic turntable, use a metal ruler to align them, then gently tap them into place with a small hammer.

Printed in PLA, but PETG is also a very good option (remember to add supports for the magnet housings).

Don't forget to apply a little grease when reassembling the build plate onto the base.

PS: If necessary, add a drop of glue to hold the magnets onto the marking pads.

Tags