Flashforge AD5X 4-in-1 Tube - Replacement tube inlet piece
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Broken the top part of the tube trying to clear it out (or mod it)? Print yourself a replacement!
- Rating
- 0 / 5
- Likes
- 52
- Downloads
- 187
- Makes
- 0
- Views
- 1,010
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
I don't charge for my functional models. Please consider purchasing some of my paid models as a way to support both my work, and this great website: https://www.printables.com/@ninjamida/store
Check out my other AD5X replacement parts, mods and upgrades (all free!).
Warnings:
- This is only a replacement part, not an upgrade of any kind.
- This is only the top part (where the tubes enter); it's NOT an entire 4-in-1 tube.
- Not tested with the V2 tube (the version with the screw); only with the older version.
So, while trying to install my 8-to-4 adapter on my AD5X - either due to excessive force from too-short tubes, or due to damage while taking it apart to install the short tubes, I'm not sure which (but suspect the latter based on visual inspection) - I ended up damaging the tabs on the top part making it unable to reliably hold.
What would most people do? Buy a new one.
What would I do? Take the thing apart further and design a printable replacement. (Actually, both.)
Print four of the collet and one of the main part.
I strongly recommend using a 0.25mm nozzle for the main part. Print very slow (20 - 40mm/s). It's designed for 0.125mm layer heights (first layer included), in particular note that the main body's model has supports built into it (as none of the support styles provided by OrcaSlicer work well for the tabs) that have a 0.125mm Z seperation. Use Classic wall generator, with 0.25mm line widths (all lines, not just walls).
For the collets, a 0.4mm nozzle is probably fine but layer adhesion is very important. Print slow again, and it may be worth using a slightly higher nozzle temperature than you usually would, especially if printing in ABS.
Install the collets, place the metal grip rings in place (I find it easier to place them in the main body of the 4-in-1 rather than on this printed piece, but YMMV), then push the part into place. Reasonable force is needed.
If you need to remove this piece, force the tabs inwards. This will likely ruin the piece itself, but you can easily just print another one - better that than ruining the less-replaceable 4-in-1, especially if you have the older version.
While I haven’t put as much focus on this, it should be possible to use these collets with the official main piece or vice versa if needed.
(PS: If you're asking "how do I print this without a working tube" - you can direct feed into the extruder, or run a PTFE tube from a single IFS channel to the extruder.)