1 / 2
SpaceMouse Top Knob 3dconnexion
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replaces top portion that has a rubber coating that gets sticky after time.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 10
- Makes
- 0
- Views
- 80
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is the top portion of a spacemouse from 3dconnexion. It has a rubber coating that over time breaks down and becomes sticky and gross. Simply pop the top cap off yours, unscrew the 3 screws, remove the old top knob, and slide this one on. Align the 3 screw holes, tighten pop the center cap on with a firm push and youre good to go. be sure to line up the center cap properly or you will break off the retention tabs.