Ford Maverick Mangoal 4K Dashcam Shim for proper alignment - model: MGA 032DBA
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3D-printed alignment shim for the Mangoal Ford Maverick 4K Dashcam (Model: MGA 032DBA), designed to correct camera angle
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 46
- Makes
- 0
- Views
- 300
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution
This is a custom 3D-printed alignment shim designed specifically for the Mangoal Ford Maverick 4K Dashcam (Model: MGA 032DBA). Its purpose is to correct the factory camera angle, which can otherwise capture an excessive amount of the vehicle’s hood and limit forward visibility. By slightly adjusting the mounting angle, the shim helps ensure a more balanced and practical field of view—especially important for capturing details like traffic signals and road conditions.
The design is lightweight and optimized to fit seamlessly between the dashcam mount and the windshield interface without interfering with installation or stability. To maintain performance in a high-temperature automotive environment, the shim should be printed using ASA or a comparable heat-resistant material, as interior vehicle temperatures can rise significantly in direct sunlight. Additionally, a low infill setting (around 10%) is recommended to reduce weight while still providing sufficient structural integrity for this application.
To use this shim, you’ll need to transfer the rear two hole locations to the camera and install M3 heat-set inserts into the housing. The front clips on the Mangoal bracket will require a small amount of filing to lower the friction point and better align it with the shim angle. I’ll try to post photos later, but I’ll need to remove the camera to get them—I didn’t do a great job capturing pictures during the initial testing.